Ford TOURNEO CONNECT, Owner'S Manual, Page: 132 / 437

curate and lead to functional restrictions of
the auxiliary heater.
Programming the auxiliary heater
and auxiliary ventilation
Please refer to , and at the
start of the chapter on page 128.
The auxiliary heater can be programmed in
the Infotainment system.
Setting the running time of the auxili-
ary heater
1. Open the Auxiliary heater menu.
2. Tap to open the Settings menu.
3. Set the running time by means of the
or function buttons.
The set running time applies when the
auxiliary heater is switched on with the
immediate heat function or using the
remote control.
The maximum running time of the auxiliary
heater is 60 minutes.
Setting desired temperature
You may only be able to set the desired
temperature of the auxiliary heater with the
Automatic Climate Control, depending on
the equipment.
1. Open the
Auxiliary heater menu.
2. Set the desired temperature by means
of the or function buttons.
The auxiliary heater warms up the inte-
rior depending on the desired tempera-
ture. The vehicle interior warms up
evenly.
Programming departure time
Activation is for one heating or ventilation
period only. The departure time must be
activated for every start.
1. Before programming, check that the
date and time set in the vehicle are cor-
rect → page 33.
2. Open the Auxiliary heater menu.
3. Tap one of the memory locations for
a Departure time .
4. Set the desired day of the week and de-
sired departure time.
Tap the
At
function button to select the
same departure time for every day of
the week.
5. Tap the function button.
6. Tap the checkbox to activate the depar-
ture time.
Automatic Climate Control: On the basis
of the programmed departure time, the
vehicle automatically calculates the
start time for heating or ventilation to
the currently set temperature depend-
ing on the outside temperature.
The earliest programmed departure
time is displayed in the Exit menu in the
Infotainment system, where you can al-
so switch it on or
off.
Programming check
If a departure time has been activated, the
yellow LED in the instrument cluster will
light up for approximately 10 seconds
after
the ignition is switched off.
Troubleshooting
Please refer to , and at the
start of the chapter on page 128.
The auxiliary heater is not switched on.
— The charge level of the 12-volt vehicle
battery is too low.
The 12-volt vehicle battery will be dis-
charged if the auxiliary heater runs sever-
al times for an extended period. Drive the
vehicle for an appropriate distance in or-
der to recharge the 12-volt vehicle bat-
tery.
— There is only the reserve fuel quantity left
in the fuel tank.
Water vapour under the vehicle
If the outside humidity is high and the out-
side temperature low, condensation may
evaporate when the auxiliary heater is run-
ning. If this is the case, steam may appear
underneath the vehicle. The vehicle is not
damaged.
130 Heating and air conditioning system