To reprogram the remote entry
transmitters:
1. Ensure the vehicle is
electronically unlocked.
2. Put the key in the ignition.
3. Turn the key from the 2 (LOCK)
position to 3 (OFF).
4. Cycle eight times rapidly (within
10 seconds) between the 3 (OFF)
position and 4 (ON).
Note:
The
eighth turn must end in the 4 (ON) position.
5. The doors will lock, then unlock, to confirm that the programming
mode has been activated.
6. Within 20 seconds press any button on the remote entry transmitter.
Note:
If more than 20 seconds have passed you will need to start the
procedure over again.
7. The doors will lock, then unlock, to confirm that this remote entry
transmitter has been programmed.
8. Repeat Step 6 to program each additional remote entry transmitter.
9. Turn the ignition to the 3 (OFF) position after you have finished
programming all of the remote entry transmitters.
Note:
After 20
seconds, you will automatically exit the programming mode.
10. The doors will lock, then unlock, to confirm that the programming
mode has been exited.
Illuminated entry
The interior lamps illuminate when the remote entry system is used to
unlock the door(s).
The illuminated entry system will turn off the interior lights if:
•
the ignition switch is turned to the ON position, or
•
the remote transmitter lock control is pressed, or
•
after 25 seconds of illumination.
The dome lamp control (if equipped) must
not
be set to the OFF
position for the illuminated entry system to operate.
The inside lights will not turn off if:
•
they have been turned on with the dimmer control, or
•
any door is open.
3
2
1
5
4
2003 F250/350/450/550
(f23)
Owners Guide (post-2002-fmt)
USA English
(fus)
Locks and Security
70
Summary of Contents for 2003 F250
Page 280: ...280 ...
