Fona Aquamarine, Operating Instructions Manual

Page: 33 / 78

Operating Instructions
båÖäáëÜ
cê~å´~áë
33
3. Position the packaging tube with the single-use fiber tip on the
connection socket by placing the funnel-shaped end of the packaging
on the handpiece.
4. Press the packaging tube with the single-use fiber tip with light
pressure against the handpiece, until the single-use fiber tip
perceptibly clicks into place and is firmly seated.
5. Subtract the packaging tube from the handpiece and the connected
single-use fiber tip.
6. Please check whether the single-use fiber tip is firmly seated on the
handpiece and perform a visual check to make sure that it has not
been damaged during shipment.
7. Put the laser into operation by choosing any preset treatment. A
corresponding description is provided in chapter "Operation".
8. As soon as the Aquamarine is ready you can check to make sure that
the aiming beam illuminates evenly, i.e. projects a circular light
pattern (see adjacent picture).To do this, aim the single-use fiber tip
vertically at a white background. If the beam shows no pattern or the
beam pattern is not illuminated evenly, the single-use fiber tip may be
damaged or defective. In this case, return the single-use fiber tip to
your dental dealer so that it can be replaced under warranty. Do not
use any defective single-use fiber tips.
WARNING
Use of the laser unit when the aiming beam is not functioning properly
may cause injuries to operating personnel, assistants or patients. If you
cannot see the red aiming beam after switching the laser on or during
treatment refer to chapter "Troubleshooting of simple defects".
WARNING
The aiming beam must not be aimed toward a person‘s eye. It
comprises an intensive light source even when set to a low power level.
Always wear protective goggles.