Fona Aquamarine, Operating Instructions Manual

Page: 32 / 78

32
Aquamarine
4.4.2.3.2 Preparation for clinical application
1. The UniTip 320µm and EndoTip 200µm are delivered sterile. The
handpiece sleeve can be cleaned in the autoclave (high-pressure
sterilizer), see chapter "Cleaning, disinfection and sterilization".
2. Select the required sterile fiber tip (UniTip 320µm or EndoTip 200µm),
see chapter "List of preset indications".
Mounting of the UniTip 320µm and EndoTip 200µm:
Do not use the single-use fiber tip if its packaging tube is damaged or the
best-before date has expired. The best-before date is printed on the
product label of the packaging tube.
1. Remove the protective cap from the connection socket at the
handpiece.
2. Open the sterile transport packaging tube of the UniTip 320µm/
EndoTip 200µm by tearing off the seal label from the top of the
packaging.
WARNING
Do not sterilize the single-use fiber tips again after usage. Sterilization
effects strongly the characteristics of the single-use fiber tips (laser
power output, form, accuracy,…).
WARNING
Never use the laser without optical fiber, check for correct fixation. Never
bend, fold or jam the single-use fiber tips, as this might cause it to break.
The single-use fiber tips must never be bent without the bending tool.
Never pull on the optical fiber of the single-use fiber tips.
WARNING
If the single-use fiber tip is used after the best-before date, the required
sterile conditions of the single-use fiber tip in the packaging tube are
only covered until the best-before date. Moreover, some of its physical
properties, e.g. its load carrying capacity and transmission behavior,
may change, thus posing a hazard to the health of the patient, the
dentist and the dental assistant.
After removal of a tip, immediately lose the outer packaging.
WARNING
Remove the protection cap for treatment only.Never touch the proximal
end of the ferrule and protect them against damage and dirt.