Manual # 26-0111000-00 / Revision D
ScreenPro PLUS – Multi-Screen Seamless Switcher 79
Select Group
SG
[g]
Description:
This command selects a set of groups. See “Group Selection” section above for a detailed
description on how this works.
Parameters:
[g] – Group selection bitmap, 1-Hex digit.
Example:
SG A
Selects GROUPS 2 and 4
SG F
Selects GROUPS 1, 2, 3, and 4
Select Input
SI
[dddd] [bus] [src #]
Description:
This command selects a preview or program input source for the specified destination.
Parameters:
[dddd] – bitmap of selected destinations, maximum of 4-Hex digits
[bus]
– bus selection,
V
or
P
= Preview,
G
or
M
= Program (Main)
[src #]
– 1 to 8 for FC-0608, 1 to 12 for FC-0612, 1 to 16 for FC-0616
Example:
SI 7 V 8
Selects input 8 to preview screens 1, 2 and 3
SI 1 G 1
Selects input 1 to program screen 1
SI 27 P 12
Selects Input 12 to preview screens 1, 2 and 3 and sets AUX 1 to get Input
12 on the next transition.
Transition Setup
TRNSETUP
[[type]
=
[value]] <[type]
=
[value]> … <[type]
=
[value]>
Description:
This command allows the setup of the transition parameters. These parameters are used when
either an “AUTO TRANS” key is pressed or the ATRN command is used.
Parameters:
At least one set of parameters must be specified. [type]
=
[value] are defined as follows:
[type] [value]
Description
R
0.0 to 5.0 seconds
Single-screen transition rate
MR
0.0 to 5.0 seconds
Multi-screens transition rate
Transition effect type specification.
ET
1 to 12
1=Dissolve
2=Wipe Left
3=Wipe Right
4=Wipe Up
5=Wipe Down
6=Curtain Close
7=Curtain Open
8=Mosaic
9=Multi-Curtain Close
10=Multi-Curtain Open
11=Multi-Wipe Right
12=Multi-Wipe Left
Effect width specification.
EW
0 to 6
0=256 pixels
1=128 pixels
2=64 pixels
3=32 pixels
4=16 pixels
5=8 pixels
6=4 pixels
Example:
TRNSETUP MR=3.0
Sets multi-screens transition rate to 3 seconds.
TRNSETUP ET=1 R=1.2 EW=4
Set transition effect type to Dissolve, single-screen rate to 1.2
seconds, and edge width to 16 pixels.
