Manual # 26-0111000-00 / Revision D
ScreenPro PLUS – Multi-Screen Seamless Switcher 75
Serial Remote Commands
ATRN
<
G=
[g]|
D=
[dddd]>
Performs an auto transition on the destinations or groups if specified. If
not, the operation will be applied to all currently active destinations.
BPQUERY
[BP query command]
Queries BlendPro for raw binary data.
FSB
[dddd] [bus]
Forces program or preview bus of the selected screens black.
FZ
[dddd] [bus] [mode]
Freezes/Unfreezes program or preview for selected screens.
GA
[groupNum] [dddd]
Assigns specific destinations to a group.
HELP
or
?
Displays the available commands and brief description.
KEY
[sn] [mode] <threshold>
Luminance keying control for a particular screen at a given threshold.
KP
[row#] [key#]
Emulates a key press.
KPR
[row#] [key#]
Emulates a key press and an immediate key release.
KR
[row#] [key#]
Emulates a key release.
NBP
Displays the number of BlendPros and their RS485 IDs.
PASS
[RS485 command] [checksum]
Pass the RS485 command to the RS485 port when there’s no
checksum error.
RE
[user preset file #]
Recall the specified user preset file followed by an auto transition.
RP
[user preset file #]
Recall the specified user preset file.
SD
[dddd]
Select destination(s) as indicated by the destination bitmap.
SG
[g]
Select group(s) as indicated by the group bitmap.
SI
[dddd] [bus] [source #]
Select a preview or program input source for the specified
destinations.
TRNSETUP
[[type]
=
[value]]
Transition parameters setup.
Controller Serial Command List/Description
Auto Transition
ATRN
<
G=
[g] |
D=
[dddd]>
Description:
Performs an Auto Transition on the destinations or groups if specified. If NOT, the operation will be
applied to the currently selected destinations. The currently selected Effect type, rate, and edge
width will be used to transition preview to program. See the TRNSETUP command for changing the
transition rates, type, and edge width.
Parameters:
The argument to this command is optional and is used to either select a set of groups or
destinations. For group selection, set the argument to
G=
[g], where g is the group bitmap. For
destination selection, set the argument to
D=
[dddd], where dddd is the destination bitmap.
Example:
ATRN
Transition Preview to Program on currently selected destinations.
ATRN G=3
Transition Preview to Program on those destinations defined by Groups 1 and 2.
ATRN D=000B
Transition Preview to Program on Screens 1, 2, and 4.
ATRN D=3C
Transition Preview to Program on Screens 3, 4, 5, and 6.
