Manual # 26-0111000-00 / Revision D
ScreenPro PLUS – Multi-Screen Seamless Switcher 47
the window be zoomed or enlarged and the top and bottom will be cropped. Note that H SIZE and V SIZE
determine the aspect ratio of the output window. Changing the aspect ratio to other than 1:1 will cause the
output to become distorted. Also, some of the video on the top and bottom will be cropped when zooming
the image. Use the +/ON key, -/OFF key, and joystick knob to adjust this parameter.
SYSTEM
Æ
DEFINE WINDOWS
Æ
H CENTER
This selection is used to specify the center, in percent, of the horizontal window. 0 is the center of the
screen. 100% is the left edge; -100% is the right edge. Use this adjustment to position the image as desired
on the output screen. Use the +/ON key, -/OFF key, and joystick knob to adjust this parameter.
SYSTEM
Æ
DEFINE WINDOWS
Æ
V CENTER
This selection is used to specify the center, in percent, of the vertical window. 100% is the top, 0% is the
center, and –100% is the bottom edge. Use this adjustment to position the image as desired on the output
screen. Use the +/ON key, -/OFF key, and joystick knob to adjust this parameter.
SYSTEM
Æ
DEFINE WINDOWS
Æ
RESET
This selection is used to clear any settings and adjustments made in this menu. Use the +/ON key to reset
the values to factory defaults.
Define Windows Example:
This example will enlarge an input source to fill three output screens horizontally starting at the top of the
image. The lower portion of the image will be cropped. Set up output screens 1, 2, and 3 in the DEFINE
WINDOWS menu as follows:
Screen: 1 2 3
Output: PREVIEW
PREVIEW PREVIEW
Mode:
ON
ON
ON
H Size:
300
300
300
V Size: 300
300
300
H Center:
100
0
-100
V Center: 100
100
100
SYSTEM
Æ
TRANSITION EDGE
This is a global adjustment that determines the fuzziness of the Wipe Edge for all of the Wipe Transitions.
The selectable options are: 4, 8, 16, 32, 64, 128 and 256 with the units being pixels. The default is 16. Use the +/ON
and -/OFF keys to change the selection.
SYSTEM
Æ
VFD BRIGHTNESS
This adjustment determines the brightness of the controller’s VFD display. To avoid “burning-in” the display, use the
lowest setting possible. This is changed using the +/ON and -/OFF keys as well as the joystick knob.
SYSTEM
Æ
SOFTWARE VERSIONS
This selection displays the software version information for all ScreenPRO Plus graphics cards in the system as well
as for the controller. For proper system operation, all graphics cards should be updated with the same software
version. If BlendPro(s) are attached, the BLENDPRO SW VERSION sub-menu will be shown and it will display the
version current installed in the BlendPro(s).
SYSTEM
Æ
TECH SUPPORT
Look at this menu for current tech support numbers that can be used on a 24/7 basis.
