www.fmiproducts.com
125898-01D
11
VENTING INSTALLATION
NOTICE: Do not seal termination
INSTALLATION PRECAUTIONS
protection
or when on roof tops
walls and ceilings
The following actions will void the warranty
on your venting system:
component
manufactured or approved by FMI
PRODUCTS, LLC
these instructions
-
-
-
on the horizontal sections,
NOTICE: Read these instruc-
-
These models are tested and approved for
pipe components and terminations.
The venting system must terminate on the
outside of the structure and can not be at-
separate solid fuel or gas burning appliance.
A direct vent appliance must have its own
venting system. DO NOT common vent this
appliance.
These models are approved to be vented
either horizontally through an outside wall or
vertically through a roof or chase enclosure
using the following guidelines:
-
tally on an outside wall, you may install
a standoff if the termination cap is to be
such as vinyl, wood, stucco, etc.
cause excessive temperatures which could
-
bustibles are 1" on all sides except on the
horizontal sections, which requires 2" clear-
ance from the top of the pipe. Where the
termination cap penetrates a combustible
wall, 1" air space clearance is required.
-
nents on hand to help determine the exact
measurements when elbowing or offsetting.
-
ings or attic spaces.
4000 feet or greater, pay special attention
to venting requirement recommendations.
WARNING: Read all instruc-
Failure to do so could result in
NOTICE: Failure to follow these
