www.fmiproducts.com
125898-01D
30
GAS CONTROL MODULE SYSTEM
The module has 2 special features built into
the system.
Continuous Pilot Feature
This allows the change from a spark to pilot
system to a standing pilot system
1. There is a switch located on the right side
of the module that reads CONTINUOUS
PILOT ON/OFF. This switch selects the
2. When the continuous pilot switch is in the OFF
position and the appliance rocker switch
is turned ON, the pilot will spark and light.
When the appliance rocker switch is turned
OFF, the pilot will shut OFF when the main
burner shuts OFF.
3. When the continuous pilot switch is in the ON
position and the appliance rocker switch
is turned ON, the pilot will spark and light.
When the appliance rocker switch is turned
OFF, the pilot will stay ON when the main
burner shuts OFF.
Remote Control Feature
The module has a built in remote control
receiver that allows the user to
program the remote transmitter at any
time during or after the installation of
the burner.
1. There is a switch located on the right side
of the module that reads REMOTE/OFF
2. When the remote/off switch is in the OFF
position, the burner will operate from the
rocker switch or wall switch connected to
the two BROWN wires on the module.
Continuous Pilot
Off/On Switch
Remote/Off Switch
ADJ.
“S” Pilot Connection
“I” Pilot Connection
Figure 40 - Gas Module Right Side
3. When the remote/off is in the REMOTE
position the burner will operate from the
Remote Control transmitter.
NOTE: The module must be programmed to
the Remote Control transmitter.
To program the module (make sure the sys-
on left side as shown in Figure 41. Press
and release the learn button. There will
be a beep sound from the module. Then
press any button on the remote transmit-
ter. Once the module's internal receiver
accepts the transmitter code, there will
The remote system is ready for use.
NOTE: Make sure the valve module and light
module are plugged into the electric duct
assembly.
remain operational. Make sure to periodically
check the condition of the four AA batteries
used for the battery back-up.
REMOTE CONTOL OPERATION
The installation of the transmitter batteries,
2 AAA, will activate the initial set up of the
system. Setup mode can also be activated
at any time by pressing the FLAME REAR
and PROG/TIME buttons simultaneously for
5 seconds. The control will automatically exit
setup mode if no button is pressed within 20
seconds.
This system will allow the temperature unit
conversion, gas type conversion, and clock
set up while in Setup mode per the following
setup procedure.
Setting of C/ F conversion:
- C/ F conversion: Use UP or DOWN key to
choose Celsius or Fahrenheit, Press "SET"
button to continue to gas type setup.
Clock Setup:
- Use UP or DOWN key to set HOUR, then
then press SET to enter AM/PM setting.
- Use UP or DOWN key to set AM/PM, the
press SET to enter day of week setting.
- Use UP of DOWN key to select the day of
the week.
AUX Connection
Learn Button
Figure 41 - Gas Module Left Side
