REPLACING SUPER-STRUTS
52
Fluid Management
®
7. Beginning with the FRONT strut, tighten the top nut until the bottom
rubber grommet is compressed 1/2".
8. Tighten the BOTTOM screw until the top rubber grommet is also
compressed to 1/2".
9. Moving to the REAR strut, tighten the TOP nut until the bottom rubber
grommet is compressed 1/2".
10. Insert the 1/8" hex wrench into the strut pin and tighten the BOTTOM
screw until the top rubber grommet is compressed to 1/2". Remove the
hex wrench from the strut pin.
11. To change the struts on the other side of the mixer, repeat these steps
beginning with Step 1 under “REMOVING THE STRUTS” on page 46.
