ADJUSTING CLAMPING FORCE
5G Paint Mixer Instruction Manual
43
6. Assure that the E-Stop button is released and press the power "ON"
switch.
7. Press the "UP" button on the control box.
8. Open the door and place the positioning spacer (P/N 24096) and gauge
(P/N 24124) on the bottom plate against the back lip as shown.
Figure 13 Gauge Position
9. Press the "START" button. The top plate will clamp the gauge without
going into the shaking cycle. WARNING: If wire was not removed in
step # 3, the mixer will shake, possibly causing damage or injury.
10. After clamping, read and record the force on the gauge.
11. Place the power switch in the "OFF" position, wait about five (5) sec-
onds and return it to the "ON" position.
12. Press the "UP" button.
13. If the force is at the "lower limit" or less, change the adjustment switch
to the next lowest number and go to step #9. If the force is at the "upper
limit" or greater, change the adjustment switch to the next highest num-
ber and go to to step #9. If the force falls within the target, go to the next
step. Refer the table on page 1 for upper and lower limits.
14. Press the power “OFF” switch.
15. Remove the gauge and spacer.
16. Unplug the power cord from the electrical outlet.
17. Place the wire back on the upper left terminal on the shake relay.
18. Close the control box and insert the screws.
19. Plug the power cord into the electrical outlet.
At this point, the mixer is ready for normal operation.
BOTTOM
PLATE
GAUGE
POSITIONING
SPACER
BACK
LIP
NOTE:
POSITIONING IS
CRITICAL. USE
THE POSITIONING
SPACER. BE SURE
GAUGE IS CENTERED
4-5/8”
& 4-5/8” FROM BACK LIP.