REMOVING SHAKE FRAME
5G Paint Mixer Instruction Manual
33
REMOVE THE COUNTERWEIGHTS
1. In order to access the nuts on the flange bearings, and the rear screws
and nuts on the pillow block bearings, remove the two (2) lower inner
frame counterweights. DO NOT REMOVE the two upper inner frame
counterweights. Use two (2) 1/2" wrenches, or a ratchet and a 1/2"
wrench, take off the two (2) lower nuts and screws holding the lower
weights to the inner frame to allow access to the crankshaft.
2. With two (2) 1/2" wrenches or a ratchet and a 1/2" wrench, loosen BUT
DON’T REMOVE, the four (4) screws securing the flange bearings to
the shake frame. Remove the four (4) nuts.
Figure 9 Flange Bearings
3. With a 1/8" hex wrench, loosen the two (2) set screws holding the crank-
shaft to the flange bearings. Remove the flange bearings. If necessary,
use a wheel puller to pry the flange bearing from the crankshaft.
The weights for the inner frame are 21
pounds each!
CAUTION:
FLANGE
WASHER
FLANGE
FLANGE
BEARING
BEARING
NUT
BEARING
SCREW
