7
2.3 Receiver Overview
Power/Bind Port
To Servos
PPM Output /To Servos
Antenna
Status Indicator
i-BUS Sensor Interface
i-BUS Serial Interface
2.3.1 Receiver Antenna
Attention
•
Do not pull or tie the antenna or use the antenna as a servo cable.
2.3.3 Ports
Power, Bind, Channel,Serial and PPM output ports for connecting various components to the receiver.
•
PPM/CH1:Can be connected to servo or used as a PPM output.
•
CH2 ~ CH10: Can be connected to servos, power supply or other compatible components.
•
B/VCC: During the binding process a bind cable is connected here. During normal opertaion the power
is applied to this port.
•
i-Bus Serial Interface: For connecting an i-BUS module, expansion.
•
i-Bus Sensor Interface: For connecting sensors.
2.3.2 Status Indicator
The status indicator is used to indicate the power and working status of the receiver.
•
Off: the power is not connected.
•
Lit in red: the receiver is on and working.
•
Flashing quickly: the receiver is binding mode.
•
Flashing slowly: the bound transmitter is off or signal is lost.
FS-iA10B uses dual 26mm antenna and can receive and send information at the same time.