17
This function enables the user to adjust the ratio between stick and servo movement using a linear line or non-
linear curves.
•
If the airplane does not have an engine, such as a glider, this icon will not be displayed.
This is useful when wanting to change how the throttle reacts at between different stick positions, for example
having a smaller throttle change when the stick is between 0-30%, then a larger throttle change between 30%
and 100%. If your models throttle is not linear, it is also possible to use this function to create a more linear
movement.
Curve Type
The number of points in the curve is shown below the line graph, L being the lowest point and H being the
highest point.
6.6 Aileron to Rudder
(Pic.10)
The aileron to rudder automatically creates a coordinated turn for the aircraft with
aileron and rudder.
The pre-programmed mix is 10% by default, meaning that if your aileron has
moves to 100% of its range of movement the rudder will move 10%.
If the aircraft does not have ailerons or a rudder, these function icon will not be
displayed.
When this function is activated, a tick will be shown on the bottom left side of the
screen, if not press the bottom left icon.
6.7 Rudder to Aileron
(Pic.11)
This function can be used to counteract undesirable roll of aircraft with rudders
and ailerons.
The pre-programmed mix is 10% by default, meaning that if your rudder has
moves to 100% of its range of movement the aileron will move 10%.
Pic.10
Pic.11
Setup:
1. Activate the function by touching the function on/off icon
located at the
bottom left of the screen.
2. Touch
[High side rate]
or
[Low side rate]
to select.
3. Use the wheel to change the value. Repeat as necessary.
•
This function must be set as active before use.
•
This function can be toggled using a switch/button, which is assigned in
the
[Keys function]
.
•
This function can be set with up to 5 conditions.
Setup:
1. Activate the function by touching the function on/off icon
located at the
bottom left of the screen.
2. Touch
[High side rate]
or
[Low side rate]
to select.
3. Use the wheel to change the value. Repeat as necessary.
•
This function must be set as active before use.
•
This function can be set with up to 5 conditions.
6.8 Throttle Curve
(Pic.12)
