5
2.2.1 Transmitter Antenna
Note
•
To ensure high signal quality, the antenna should be perpendicular to the models
fuselage. When adjusting the angle of the antenna, make sure that the antenna does
not point directly towards the front or back of the model.
Note
•
Never grip the transmitter antenna during operation. It significantly degrades signal
quality and strength and may cause loss of control.
Note
•
Do not bend the antenna wire beyond 90 degrees. Bending the antenna further
could result in damage to the wire.
2.2.2 Stick/Knob/Switch
The FS-i10 has 2 gimbals, 8 switches and 5 knobs, 3 of which can be locked.
•
Sticks: The sticks are used for rudder, elevator, alieron and throttle control.
•
Switches: The switches can be assigned to various functions for quick access.
•
Knob/VR: The knobs/VRsc an be assigned to various functions to make quick adjustments during use.
Lockable rotary knob: Press the knob down to lock it into position. To bring the knob back up, press
down again and release after which the knob can be rotated normally.
2.2.3 Status Indicator
The status indicator is used to indicate the power and working status of the transmitter.
•
Off: the transmitter is powered off.
•
Blue light: the transmitter is on and working.
•
Flashing: low voltage alarm.
2.2.4 Trims
There are 4 groups of trim switches affecting surface position. Each time a trim is toggled, the trim will move
one step. You can hold the trim in the desired direction to make quicker trim adjustments. When the trim
position reaches the middle, the transmitter beeps in a higher tone.
2.2.5 SD Card
This system only supports SD 2.0 with a capacity of 1GB or above.
Supports Model Import and export. Refere to 【6.25Models】 for details.
Note
•
Turn off the transmitter before removing SD card.
