Fluke SigmaPace 1000, Operator'S Manual, Page: 29 / 154

Introduction and Specifications
Instrument Specifications
1
1-15
Amplitude Sensitivity Test
Physiological Simulation
Selection ............................................................. +R-Wave, -S-Wave, and + T-Wave
Rate (Interval) ..................................................... Default: 120 BPM (500 mS)
Available Test Load
Selection(s)......................................................... (30) 50
Ω
to 1550
Ω
in 50
Ω
steps
Waveform Selections.......................................... Square (SQU)
Triangle (TRI)
Haversine (HSN)
SSQ
Amplitude
Range ................................................................. 0.05 mV
peak
(50 V
peak
) to 5.0 mV
peak
Accuracy ............................................................. ±5 % of setting
Resolution (Step Size)........................................ 0.05 mV steps from 0.05 mV
peak
to 0.
95 mV
peak
0.50 mV steps from 1.0
mV
peak
to 5.0 mV
peak
Width
Range ................................................................. 0.15 mS to 300 mS
Accuracy ............................................................. ±5 % of setting
Selection Count .................................................. 50
Resolution (Step Size)........................................ 0.05 mS steps from 0.15 mS to 0.95
mS
1.0 mS steps from 1.0 mS to 19.0 mS
5.0 mS steps from 20 mS to 95.0 mS
25 mS steps from 100 mS to 300 mS
Active Outputs
Five lead ECG
Selected Ventricular Channel Test Load
High Level ECG Jack
This waveform is present on these three outputs.
Pacemaker Compatibility
Compatible Pulse Rates ..................................... 30 to 200 PPM (Minimum)
Intended Pacemaker Type.................................. VVI (Ventricular Pace and Sense
Only)
Noise Immunity Test
Waveform .............................................................. Sine Wave
Frequency .............................................................. 50 and 60 Hz
Accuracy ................................................................ 0.5 Hz