Fluke DTX-1800, Technical Reference Handbook

Page: 42 / 398

DTX Series CableAnalyzer
Technical Reference Handbook
1-16
Changing the Language
To change the tester’s language:
1 Turn the rotary switch to SETUP.
2 Use
D
to highlight Instrument Settings at the
bottom of the list; then press
H
.
3 Use
C
and
D
to find and highlight Language on
tab 2 at the bottom of the list; then press
H
.
4 Use
D
to highlight the desired language; then
press
H
.
5 Use the arrow keys and
H
to find and change other
local settings on tabs 2, 3, and 4 under Instrument
Settings.
Powering the Tester
W
Warning
*
Read the safety information starting on page 1-8
before using the tester.
You may power the tester with the ac adapter included or
with the removable lithium ion battery pack.
If the tester does not turn on, refer to “If Something Seems
Wrong” on page 14-9.
Charging the Battery
To charge the battery, connect the ac adapter to the
battery pack, as shown in Figure 1-4.
You may charge the battery when it is attached or
detached from the tester. Figure 1-4 shows how to remove
the battery.
The battery charges fully in about 4 hours with the tester
off. A fully-charged battery lasts for at least 12 hours of
typical use.
Note
The battery will not charge at temperatures
outside of 0 °C to 45 °C (32 °F to 113 °F). The
battery charges at a reduced rate between 40 °C
and 45 °C (104 °F and 113 °F).
•
If the battery does not reach full charge within 6 hours,
the battery LED flashes red. Verify that the battery was
within the temperature range given above during
charging and that the correct ac adapter was used.
Disconnect then reconnect ac power and try charging
the battery again. If the battery does not charge the
second time, retrain the battery gauge as described on
page 14-6.
•
If the battery LED flashes red or the tester will not turn
on, see “If Something Seems Wrong” on page 14-9.