Fluke 19xC, User Manual

Page: 125 / 159

Specifications
Dual Input Oscilloscope
10
115
Scope Record Mode ......... >27000 points on each input
Scope Normal Mode ............. 3000 points on each input
Scope Glitch Capture Mode ..............300 min/max pairs
on each input
Glitch Detection
5
μ
s to 120 s/div......... displays glitches as fast as 50 ns
Waveform Display.................A, B, A+B, A-B, A*B, A vs B
Normal, Average (2,4,8,64 x), Persistence
Time Base Accuracy ...................... ±(100 ppm + 0.04 div)
Trigger and Delay
Trigger Modes........................................Automatic, Edge,
External, Video, Pulse Width
N-Cycle
Trigger Delay ................................. up to +1200 divisions
Pre Trigger View ............................. one full screen length
Max. Delay......................................................12 seconds
Automatic Connect-and-View Trigger
Source .............................................................. A, B, EXT
Slope........................................... Positive, Negative, Dual
Edge Trigger
Screen Update............Free Run, On Trigger, Single Shot
Source .............................................................. A, B, EXT
Slope...........................................Positive, Negative, Dual
Trigger Level Control Range ..........................
±
4 divisions
Trigger Sensitivity A and B
DC to 5 MHz at >5 mV/div.......................... 0.5 divisions
DC to 5 MHz at 2 mV/div and 5 mV/div ...........1 division
200 MHz (FLUKE 199C, 225C) .......................1 division
250 MHz (FLUKE 199C, 225C) .....................2 divisions
100 MHz (FLUKE 196C, 215C) .......................1 division
150 MHz (FLUKE 196C, 215C) .....................2 divisions
60 MHz (FLUKE 192C)....................................1 division
100 MHz (FLUKE 19CB) ...............................2 divisions
Isolated External Trigger
Bandwidth ............................................................. 10 kHz
Modes .................................................... Automatic, Edge
Trigger Levels (DC to 10 kHz)....................120 mV, 1.2 V
Video Trigger
Standards..............................PAL, PAL+, NTSC, SECAM
Modes ......................Lines, Line Select, Field 1 or Field 2
Source............................................................................ A
Polarity ................................................. Positive, Negative
Sensitivity ....................................... 0.7 division sync level