FLIR E70290, Installation & Operation Instructions

Page: 38 / 136

5.3 Cable connection –DV, DVS, Pro
and Wi-Fish
™
The unit has a combined power and transducer
cable that is attached to the transducer.
1. Connect the transducer / power connector to
the rear of the unit and secure using the locking
collar.
2. The drain wire should be connected to the vessel
RF ground point. If your vessel has no ground
point connect to the negative side of the vessel’s
power supply.
3. The Negative wire must be connected to the
negative side of the 12 V dc power supply.
4. A fuse holder (not supplied) MUST be itted to
the positive wire using a suitably rated inline fuse
or breaker.
5. The positive wire must be connected to the
positive side of the 12 V dc power supply.
5.4 Connecting the power cable - 5 M
1. Connect the power cable to the rear of the display
and secure using the locking collar.
2. The drain wire should be connected to the vessel
RF ground point. If your vessel has no ground
point connect to the negative side of the vessel’s
power supply.
3. The Negative wire must be connected to the
negative side of the 12 V dc power supply.
4. A fuse holder (not supplied) MUST be itted to
the positive wire using a suitably rated inline fuse
or breaker.
5. The positive wire must be connected to the
positive side of the 12 V dc power supply.
Connecting the cable to the display
1. Ensure the locking collar is in the unlocked
position.
2. Ensure that the cable connector is orientated
correctly, rotate so that the word ‘TOP’ is on the
top of the cable connector.
38
Dragonly–4 / Dragonly–5 / Dragonly–7 / Wi–Fish