FLIR 72501-0101, User Manual

Page: 118 / 146

Fetching data from external FLIR meters 27
4. On the FLIR meter, choose the quantity that you want to use (voltage, current, resist-
ance, etc.). Refer to the user documentation for the meter for information on how to
do this.
Results from the meter will now automatically be displayed in the result table in the
top left corner of the infrared camera screen.
5. On the camera, in preview mode and when editing an image in the archive, you can
do the following:
• Push the programmable button to add the value currently displayed by the
FLIR meter.
• Push and hold the programmable button to remove all FLIR meter values from
the image.
Note Any function assigned to the programmable button is temporarily disabled
when in preview mode or when editing an image in the archive.
27.4 Typical moisture measurement and
documentation procedure
27.4.1 General
The following procedure can form the basis for other procedures using FLIR meters and
infrared cameras.
27.4.2 Procedure
Follow this procedure:
1. Use the infrared camera to identify any potential damp areas behind walls and
ceilings.
2. Use the moisture meter to measure the moisture levels at various suspect locations
that may have been found.
3. When an area of particular interest is located, store the moisture reading in the mois-
ture meter’s memory and identify the measurement area with a handprint or other
thermal identifying marker.
4. Recall the reading from the meter memory. The moisture meter will now continuously
transmit this reading to the infrared camera.
5. Use the camera to take a thermal image of the area with the identifying marker. The
stored data from the moisture meter will also be saved on the image.
27.5 More information
For more information, see the user manuals that are shipped with FLIR meters.
#T559954; r. AT/65353/65353; en-US 104