Flavor Burst FB 80S-08, Manual

Page: 59 / 76

58
3. Select the syrup flavor you wish to
use, then place the bag on the table with
the fitment up and remove the dust cap.
(See Figure 148.)
Figure 148
4. Lifting up with the bag fitment, press
the center pin of the bag fitment valve
and gently press on the bag to release
any excess air. (See Figure 149.)
Figure 149
5. Select a numbered tray to
correspond with the flavor you have
chosen.
6. Place the tray up-side-down over the
bag and pull the fitment into the tray
opening as shown. The tray opening
should slide between the grooves of the
bag fitment. (See Figure 150.)
Figure 150
7. Holding the fitment in place, raise the
open end of the tray and flip the tray
right side up. As the tray is set back
down, allow the bag to settle in the tray.
(See Figure 151.)
Figure 151
8. Make sure the syrup bag is settled
neatly into the tray, and then install the
loaded tray into the cabinet. (See
Figure 152.)
Figure 152
9. Clean the outer surfaces of the Syrup
Bag Connector with detergent water and
a single service towel and brush if
necessary. Then rinse and dry the
connector using clean water and single
service towels. (See Figure 153.)
Figure 153