27
6. Lifting up with the bag fitment, press
the center pin of the bag fitment valve
and gently press on the bag to release
any excess air. (See Figure 34.)
Figure 34
7. Place the tray up-side-down over the
bag and pull the fitment into the tray
opening as shown. The grooves of the
bag fitment should slide into the tray
opening. (See Figure 35.)
Figure 35
8. Holding the fitment in place, raise the
open end of the tray and flip the tray
right side up. As the tray is set back
down, allow the bag to settle in the tray.
(See Figure 36.)
Figure 36
9. Make sure the syrup bag is settled
neatly into the tray, and then install the
loaded tray into the cabinet. (See
Figure 37.)
Figure 37
10. Clean the exposed surfaces of the
Syrup Bag Connector and bag fitment
with detergent water and a single
service towel and brush if necessary.
Then rinse and dry the connector and
fitment using clean water and single
service towels. (See Figure 38.)
Figure 38
11. Using a spray bottle of approved
sanitizer solution, spray the syrup bag
fitment and the Syrup Bag Connector.
Allow these parts to sanitize for at least
1 minute. (See Figure 39.)
Figure 39
Summary of Contents for FB 80S-08
