Flavor Burst FB 80S-08, Manual

Page: 39 / 76

38
6. Remove each component from the
sanitizer solution and place them on a
sanitary tray to air dry. (See Figure 75.)
Figure 75
7. Lube the black o-rings and place
them in their respective positions on the
Blending Adapter. (See Figure 76.)
Figure 76
8. Clean the freezer door and spout
according to manufacturer’s instructions
before installing the Blending Adapter
on the freezer door.
9. Set the Adapter on a flat, clean
surface, and then place the freezer door
spout upright onto the Adapter. Rock
the freezer door forward to snap the
Adapter into place. (See Figure 77.)
Figure 77
10. Install the freezer door with the
Blending Adapter attached to the
freezer.
Replacing Blending Head O-Ring
The Blending Head o-ring is a wear item
and will need to be replaced
periodically. Always keep a spare o-ring
on hand in the Spare Parts Kit for
replacement.
1. Mix approved detergent with warm
water according to manufacturer’s
instructions. Also prepare approved
sanitizer solution according to
manufacturer’s instructions.
2. Remove the worn o-ring from the
Blending Head. A small tool may be
needed to remove the o-ring in the
syrup line opening. (See Figure 78.)
Figure 78
3. Place the replacement o-ring in
approved sanitizer solution and soak for
at least 1 minute. (See Figure 79.)
Figure 79