Flavor Burst FB 80S-08, Manual

Page: 51 / 76

50
2. Align the 9-hole gasket with the
coupler pins of the Lead and place the
9-hole gasket on the coupler. (See
Figure 113.)
Figure 113
3. Align the coupler pins of the two
syrup lines and connect the assemblies.
(See Figure 114.)
Figure 114
4. Slide the coupler casing over the
connection and screw each coupler nut
into each end of the casing. Tighten the
coupler nuts to secure the connection.
(See Figure 115.)
Figure 115
Installing & Filling the Sanitizer Tank
The Sanitizer Tank system provides
approved sanitizer solution to specific
areas of the Flavor Burst system such
as the Blending Head and Syrup Lines
during certain functions. In order to
utilize these clean-in-place functions,
keep an adequate supply of approved
sanitizer solution in the Sanitizer Tank at
all times.
The Sanitizer Tank should be checked
on a daily basis, but only needs to be
refilled if the supply is low.
1. Prepare approximately 2 ½ gallons
(9.5 Liters) of approved sanitizer
solution according to manufacturer’s
instructions.
2. Insert one end of the sanitizer tube
into the fitting located at the lower back
of the cabinet. (See Figure 116.)
Figure 116
3. Insert the other end of the sanitizer
tube into the fitting on the Sanitizer
Tank. (See Figure 117.)
Figure 117