55
6. Place the 9-Tube Assembly, the Keypad
Cable, and the Motor Cable inside the
Casing. (See Figure 154.)
26163
Figure 154
7. Close the Casing, and press all along the
connection to secure. (See Figure 155.)
26164
Figure 155
Mounting the Accessory Hanging Bracket
The Accessory Hanging Bracket is used to
suspend the Drive Motor and 9-Tube Assembly
while other parts of the system have been
removed for cleaning. The Accessory Hanging
Bracket should be mounted in an accessible
area 6 in. or more above the 9-Tube Assembly
Casing. This will allow enough room for the
Drive Motor to hang properly.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
2. Determine the approximate area where the
Bracket will be attached on the side of the
freezer. The Bracket should be attached on
the side the 9-Tube Assembly tubes wrap
around to the back of the freezer. It should
also be installed level just below the Keypad
Bracket.
3. Clean, rinse and dry thoroughly the area on
which the Bracket will be mounted using
detergent water, clean water, and single
service towels. (See Figure 156.)
Figure 156
4. Remove the protective adhesive tape from
the adhesive strip on the Bracket. (See
Figure 157.)
Figure 157
5. Mount the Bracket to the desired area on
the freezer. (See Figure 158.)
Figure 158
Summary of Contents for FB 80D Series
