Flavor Burst FB 80D Series, Manual

Page: 49 / 81

48
2. Determine the approximate area and side of
the freezer to attach the Bracket that will
best suit your needs. Typically this is the
same side as the 9-Tube Assembly so that
the cable can be contained inside the
9-Tube Assembly Casing.
NOTE: IF YOUR FREEZER HAS AN
INTERNAL SWITCH INSTALLED, MOUNT
THE KEYPAD ON THE SAME SIDE AS THE
SWITCH JACK.
3. Thoroughly clean and dry the face of the
freezer where the Bracket base will be
attached. (See Figure 120.)
Figure 120
4. Remove the protective tape from the
adhesive pad. Attach the Keypad bracket
assembly to the desired mounting area.
Ensure there is enough room between the
Keypad assembly and the freezer face to
slide the Keypad off and on the Bracket for
daily cleaning. (See Figure 121.)
26122
Figure 121
5. Fully insert the Keypad stereo plug into the
Spigot Switch jack and ensure that the
connection is fully engaged. (See
Figure 122.)
26123
Figure 122
6. Adjust the angle of the Keypad by loosening
the bottom hand knob of the bracket and
swinging the keypad upward. The Keypad
hinges on the upper hand knob. Secure the
Bracket by tightening the hand knobs. (See
Figure 123.)
Figure 123