40
4. Clean the two o-rings, the white gasket and
the Spout Adapter with a small brush and
detergent water, and rinse thoroughly. (See
Figure 92.)
Figure 92
5. Place the Spout Adapter, o-rings, and white
gasket in approved sanitizer solution and
soak for at least 1 minute. (See Figure 93.)
Figure 93
6. Remove each part from the sanitizer
solution and place them on a sanitary tray to
air dry. (See Figure 94.)
26096
Figure 94
7. Lube the black o-rings and install them with
the white gasket in their respective positions
on the Spout Adapter. (See Figure 95.)
Figure 95
8. Clean the freezer door and spout according
to manufacturer’s instructions before
installing the Spout Adapter on the freezer
door.
9. Set the Adapter on a flat, clean surface, and
then place the freezer door spout upright
onto the Adapter. Rock the freezer door
forward to snap the Adapter into place.
(See Figure 96.)
Figure 96
10. Return the freezer door to the freezer with
the Spout Adapter attached.
Replacing Injector Head O-Rings
The Injector Head o-rings are wear items and
will need to be replaced periodically. Always
keep spares of these items on hand in the
Spare Parts Kit for replacement.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
Also prepare approved sanitizer solution
according to manufacturer’s instructions.
Summary of Contents for FB 80D Series
