Flavor Burst FB 80D Series, Manual

Page: 45 / 81

44
Accessory Hanging Bracket and 9-Tube
Assembly Casing
Figure 107
1. Using warm detergent water and a single
service towel, clean the Bracket and the
Casing attached to the freezer.
2. Rinse with a single service towel moistened
with clean water.
3. Dry the Bracket and Casing with a dry
single service towel.
9-Tube Assembly Syrup Lines
Detergent
CLEAN
Water
RINSE
DRY
26143
Figure 108
1. If it is necessary, follow instructions in
‘Phase 1’ and ‘Phase 3’ of the Clean-In-
Place procedure to clean and sanitize the
Coupler Body, Syrup Line Manifold, and the
Duckbill Check Valve.
2. Clean the Coupler Base, the end of the
syrup lines and the outside of the syrup
tubes with a single service towel moistened
with detergent water.
3. Rinse the parts using a single service towel
and warm water, then dry with a dry single
service towel.
4. Reassemble the 9-Tube Assembly if
necessary according to instructions.
Spigot Switch and Switch Bracket
ELECTRICAL HAZARD: DO NOT
IMMERSE OR USE AN EXCESSIVE AMOUNT
OF WATER OR DETERGENT IN CLEANING
THE SPIGOT SWITCH ASSEMBLY. FAILURE
TO COMPLY MAY RESULT IN SERIOUS
ELECTRICAL SHOCK.
Figure 109
1. Disconnect the Switch from the Keypad and
remove from the freezer.
2. Clean only the exposed surfaces of the
Spigot Switch such as the lever, the top of
switch and the clip bracket using a single
service towel moistened with warm
detergent water. Keep water and detergent
away from the cord and plug.
3. Rinse off detergent using a single service
towel moistened with clean, warm water and
then wipe dry with a dry single service
towel. Keep water and detergent away from
the cord and plug.
4. Dry with a dry single service towel and
install according to instructions in
EQUIPMENT SETUP.