Flavor Burst FB 80D Series, Manual

Page: 55 / 81

54
6. Tighten the thumb nut and thumb screw to
secure the Suspension Bracket.
NOTE: THE SUSPENSION BRACKET
SHOULD BE POSITIONED ON THE DRIVE
ASSEMBLY GEAR BOX DURING INITIAL
SET-UP AND DOES NOT NEED TO BE
REMOVED DURING OPENING OR CLOSING
PROCEDURES UNLESS IT REQUIRES A
MORE THOROUGH CLEANING.
7. Locate the 9-Tube Assembly at the lower
back of the cabinet.
8. Fully insert the 9-Tube Assembly into the
Injector Head syrup line opening and rotate
it until motion stops to secure. (See
Figure 150.)
26044
Figure 150
Mounting the 9-Tube Assembly Casing
The 9-Tube Assembly Casing should be
mounted on the side of the freezer so that it is
level horizontally. It should be mounted at the
same height as the Injector Assembly so that
the syrup lines are level with the connection at
the Injector Head.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
2. Determine the approximate area where the
Casing will be attached on the side of the
freezer. The Casing should be attached on
the side that the 9-Tube Assembly tubes
wrap around to the back of the freezer. It
should also be installed at the same height
as the Injector Assembly and should be
level horizontally.
3. Thoroughly clean, rinse and dry the area
where the Casing will be mounted using
detergent water, clean water, and single
service towels. (See Figure 151.)
Detergent
CLEAN
Water
RINSE
DRY
26160
Figure 151
4. Remove the protective adhesive tape from
the Casing and mount the Casing to the
desired area on the freezer. (See
Figure 152.)
26161
Figure 152
5. Pry open the 9-Tube Assembly Casing.
(See Figure 153.)
26162
Figure 153