Installation
Seite/Page 150 - Kaptitel/Chapter 14: Installation
14.7.16
only an electrician may carry out the installation of the
electrical connections of the generator.
WARNING: Hot surface/material
Generator and cooling water may be hot during and after
operation. Burn/scalding hazard!
During operation, overpressure may build up in the cooling
system.
M A N D AT O RY I N S T R U C T I O N : P r o t e c t i v e
equipment required
For installation work, personal protective equipment is
compulsory. This includes:
• Tightly fitting protective clothing
• Safety shoes
• Safety gloves
• Hearing protection
• Safety goggles if applicable
WARNING: Switch off all loads.
All loads must be disconnected prior to working on the
generator to avoid damage to the devices.
14.2 Disposal of the components
M A N D AT O RY I N S T R U C T I O N : P r o t e c t t h e
environment.
Electronics components are hazardous to the
environment and contain rare raw materials.
Collect and properly dispose of components that are no
longer needed!
The iControl2 board is typically pre-installed on the generator, and the corresponding connecting lines for connecting
it to the iControl2 panel and the PMGi are prepared. See generator manual.
