Fimap MMg base, Use And Maintenance Manual, Page: 26 / 44

At the end of the work, and before carrying out any type of maintenance, perform the following operations:
1. Turn the brush head control level (1) anti-clockwise ( Fig.1 ); in this manner the brush head body will be raised off the floor.
2. Turn the squeegee control lever (2) clockwise ( Fig.2 ) to raise the squeegee body off the floor.
3. Press the drive pedal (3) ( Fig.3 ) to begin moving the machine.
4. Take the appliance to the dedicated dirty water drainage area.
5. Carry out all the procedures listed in the paragraph “RECOMMENDED PERIODIC MAINTENANCE” (in the column “AT THE END OF THE
WORK”).
6. Once the maintenance work is finished take the appliance to the designated storage place.
7. Secure the machine, see the section entitled “MACHINE SAFETY” on page 14.
ATTENTION: Park the machine in an enclosed place, on a flat surface, and at a safe distance from any objects that could either damage
it or be damaged due to contact with the machine itself.
AT THE END OF THE WORK
ROUTINE MAINTENANCE
INTERVAL
MACHINE
COMPONENTS
PROCEDURE REFERENCE
DAIL
Y
BEFORE
A LONG PERIOD OF INACTIVITY
RECOVERY TANK
Empty the recovery tank. “DRAINING THE RECOVERY TANK” on page 29
Cleaning the vacuum system filters.
“CLEANING THE RECOVERY TANK FILTERS” on page
29
SQUEEGEE BODY
Clean the vacuum chamber; the
squeegee rubber blades; the vacuum
nozzle.
“CLEANING THE SQUEEGEE BODY” on page 29
SOLUTION TANK
Empty the solution tank. “EMPTYING THE SOLUTION TANK” on page 30
Cleaning the detergent solution
recycling system filter (FLR versions).
“CLEANING THE RECYCLE FILTER (FLR VERSION)”
on page 30
DEBRIS HOPPER
(SWEEPING
VERSIONS)
Empty the debris hopper and clean
the inside of it.
“EMPTYING THE DEBRIS HOPPER (SWEEPING
VERSION)” on page 30
BRUSH HEAD BODY
Clean the brushes in the brush head
body.
“CLEANING THE BRUSH HEAD BRUSHES
(SCRUBBING VERSION)” on page 30
“CLEANING THE BRUSH HEAD BODY BRUSHES
(SWEEPING VERSION)” on page 31
Clean the abrasive pad in the brush
head body.
“CLEANING THE ABRASIVE PAD (ORBITAL VERSION)”
on page 31
Clean the brush in the side brush
head body.
“CLEANING THE SIDE BRUSH (SCRUBBING
VERSION)” on page 32
“CLEANING THE SIDE BRUSH (SWEEPING VERSION)”
on page 32
Cleaning the splashguard rubber
blades into he brush head body.
“CLEANING THE BRUSH HEAD BODY SPLASHGUARD
RUBBER BLADES (SCRUBBING VERSION)” on page
31
“CLEANING THE BRUSH HEAD BODY SPLASHGUARD
RUBBER BLADES (SWEEPING VERSION)” on page
32
26
1 2
1
2
3
3