Filtec FT-70c, Service And Technical Reference Manual

Page: 145 / 243

FT-70 Fill Level Inspector Service Manual
6-6
Conversion Factors
The following formulas may be helpful when performing the
calibration procedures:
Converting inches to millimeters:
Converting feet per minute to meters per minute:
Calculating containers per minute (cpm):
How to Determine if You Have Baseline Eight
Your FT-70 must contain Baseline Eight of the system software to
use the calibration procedures listed in this section. If you do not
have Baseline Eight, contact IDC Customer Service for instructions
pertaining to your baseline.
1. Turn the FT-70 power on, or press the reset button and the
FT-70 will begin its start-up sequence.
2. Read the software version code in the displayed status
message:
***IDC FT-70 MT:011***
VERSION:MGI STAT:0480
3. If the version code is MGI thru MZZ, TYW thru TZZ, or SAA
thru SZZ, Baseline Eight is installed. If any other version code
appears, contact IDC Customer Service for instructions.
25.4 inches millimeters =
×
3.28 feet˙ meters =
×
containers per hour
60
--------------------------------------------------- cpm =
Industrial Dynamics Company, Ltd. © 40256-0600