HIGH LEVEL INTERFACE
16
P/N 06-158
UL S3217
Rev 5, 02/2015
FM 3020297
4.2
CYBERCAT/CHEETAH XI CONFIGURATION OF VESDA UNITS
4.2.1 CONFIGURATION MENU 4
C O N F I G U R A T I O N
M E N U 4
F 1 - A C D E L
F 4- P C
M O D E
F 2 - V E S D A
F 5- P 1 2 / P 1 3
F 3 - A U X S U P
F 6- M E N U
5
Exhibit 13: Configuration Menu 4
4.2.2 VESDA
CONFIGURATION
From the CyberCat/Cheetah Xi Configuration Menu 4, Press F2 for VESDA Config.
V E S D A C O N F I G U R A T I O N
F 1 - A L A R M
F E A T U R E S
F 2 - S E C T O R
Z O N E- S
F 3 - E V A X
F 4 - R E L E A S E
Exhibit 14: VESDA Configuration Menu
4.2.3 VESDA ALARM FEATURES
From the VESDA configuration menu, press F1
V E S D A
Z O N E
N U M :
0 0 1
T Y P E :
A L M
E N A
C U S T O M M E S S A G E- V Z
0 0 1
Z O N E: 0 0 0
0 0 0 0 0 0
0 0 0
Exhibit 15: VESDA Alarm Menu
Line 1
VESDA Detector Zone number. Position the cursor under any of the 3 fields and use the +/-
buttons to change to a different zone number.
Line 2
Detector type. Select the type by positioning the cursor under that area and using the +/- keys
until the type detector installed is shown. Then arrow over to the right using the right arrow button
until under the STATE field and use +/- to select the state of operation for that detector. The
available States are ALM (Alarm), SUP (Supervisory) and TRB (Trouble)
Then use the right arrow button again to move over under the ENA field. Use the +/- keys to
enable or disable that detector
Line 3
Custom Message field for detector. Move the cursor to the field; use the +/- button to cycle
through all ASCII characters and display the desired character. Arrow to next character and
repeat until custom message is completed.
Line 4
Zone assignment. This allows you to select up to 4 CyberCat/Cheetah Xi zones that this detector
will participate in. Arrow until you get to each field, then use the +/- button to change zones to that
desired. Repeat for each of 4 zones required. Remember, Zone 255 is ANY Zone.
