Festo CTEU-DN, Description, Functions And Maintenance

Page: 67 / 130

4. Commissioning
4-11
Festo P.BE-CTEU-DN-OP+MAINT-EN en 1206NH
4.3 Parameterisation
Note
Observe the subsequent sections to ensure that the para-
meterisation required for your application is automatically
restored at switch-on, after a restart or after a device re-
placement.
Check which settings are required, especially before a
device replacement. Make sure that these settings are
retained or restored (e.g. by the higher-order
controller/PLC)
Section 2.3.
4.3.1 Methods of parameterisation
CTEU-DN can be parameterised as follows ( Tab. 4/15):
– via the configuration program
– via the scanner
– via the user program
Use the QuickConnect and Automatic Device Replacement
(ADR) DeviceNet functions or communication and program-
ming via Explicit Messaging, in order to set the required para-
meters.
In this case, the PLC automatically transmits the programmed
parameters to the bus node after switch-on. The settings will
then be retained even after a restart or device replacement.
Note
The last parameterisation received in the CTEU-DN is al-
ways valid.