Festo CTEU-DN, Description, Functions And Maintenance

Page: 36 / 130

2. Installation and interfaces
2-14
Festo P.BE-CTEU-DN-OP+MAINT-EN en 1206NH
DIL switch
1)
Function
1 2 3 4 5 6 1 2 3 4 5 6
1 2 3 4 5
DIL switch group 1
1
1 ... 6: DeviceNet address (Station Number), 0 … 63, binary-coded (factory setting: 63)
DIL switch group 2
2
1 ... 2: reserved (OFF)
3
3 ... 4: Data rate/
baud rate
2)
250 kB
2.3 2.4
125 kB
2.3 2.4
DIL 2.3: OFF
DIL 2.4: OFF
DIL 2.3: ON
DIL 2.4: OFF
Reserved
2.3 2.4
500 kB
2.3 2.4
DIL 2.3: OFF
DIL 2.4: ON
DIL 2.3: ON
DIL 2.4: ON
4
5: Diagnostics mode ON: Diagnostics activated:
Transmission of diagnostic in-
formation to the process data
OFF: Access to diagnostic in-
formation only through explicit
messaging (factory setting)
5
6: Fail-state and
idle mode
3)
ON: Hold last state OFF: Reset
(factory setting)
1)
Switch setting “ON”: (marked on DIL switch accordingly, shown in Fig. at top)
Switch setting “OFF”: (shown in Fig. at bottom)
2)
Factory setting: 125 kBaud
3)
The setting for the fail state mode and the idle mode apply for all inputs and outputs
– Fail state: no fieldbus connection (connection aborted)
– Idle state: PLC is in stop mode
Note Fail state mode is also referred to as “Fail safe mode”
Tab. 2/7: Setting the DIL switch (DIL switch group 1 and 2)