Festo CPX-FB32, Electronic Manual

Page: 107 / 136

B. Ethernet/IP Objects of the CPX−FB32
B−17
Festo P.BE−CPX−FB32−EN en 0605NH
A tt r.
n o.
F uncti o n
n o.
Typ e D esc r i p ti o n A ccess
3 Get Monitoring CPX terminal (bit 0...7)
Specifies whether the monitoring of short circuit/over
load and undervoltage is active or inactive.
Bit 0:
Monitoring short circuit/overload in the
sensor supply
Bit 1: Monitoring short circuit at the outputs
Short circuit/overload at the outputs
Bit 2: Monitoring V
out
Undervoltage at the outputs
Bit 3: Monitoring V
val
Undervoltage at valves
Bit 4: Monitoring SCV (short circuit at valves)
Bit 5...7: Reserved
0: inactive
1: active
BYTE 2 (bit 0...7)
4 Get Number of input bytes (Rx size)
Specifies the number of input bytes of the CPX terminal. BYTE
5 Get Number of output bytes (Tx size)
Specif. the number of output bytes of the CPX terminal. BYTE
9 Get/Set Monitoring (bit 0...7)
Bit 0:
Monitoring short circuit/overload in the
sensor supply
Bit 1: Monitoring short circuit/overload at the
outputs
Bit 2: Monitoring Vout (undervoltage at outputs)
Bit 3: Monitoring Vval (undervoltage at valves)
Bit 4: Monitoring SCV (short circuit at the valves)
Bit 5...7: Reserved
1: active (presetting)
0: inactive
BYTE 4401
(bit 0...7)
10 Get/Set Fail safe
0: Reset all outputs (presetting)
1: Hold last state (retain signal status)
2: Assume fault mode BYTE 4402
(bit 0, 1)
11 Get/Set Force mode
0: blocked
1: enabled BYTE 4402
(bit 2, 3)