Festo CPX-FB32, Electronic Manual

Page: 32 / 136

1. Installation
1−16
Festo P.BE−CPX−FB32−EN en 0605NH
1.3.4 Extended Ethernet settings
Via the Ethernet Link Object" (see appendix B.2.3) you can
undertake further settings for the Ethernet connection. Confi
gure the Ethernet Link Object via your Ethernet/IP master or
scanner. The extended Ethernet settings are described below.
A ut o matic settin g (f act ory settin g)
The field bus baud rate and the Duplex mode are recognized
as standard by the CPX−FB32.
B au d r ate
The field bus baud rate can be switched via EtherNet/IP and
is set via Attribute no. 6 (Interface Speed) of the Ethernet Link
Object. The following settings are possible:
10 MBd
100 MBd
D u pl e x m od e
The full Duplex mode can be activated/deactivated.
1.3.5 Use the Webserver functions of the CPX−FB32
A Webserver is incorporated in the CPX−FB32. The Webserver
can be used freely. You can copy files onto the Webserver via
FTP. Information on using the FTP can be found in the appen
dix A.1.
Use the CPX Web Monitor" software (part number 545413),
in order to use all the functions of the Webserver optimally
and user−friendly.
With the CPX Web Monitor you can load a visualization pack
age on an HTLM basis into the Webserver of the FB32. User−
friendly diagnostic possibilities are then available via the
Ethernet network.