Festo CPX-FB32, Electronic Manual

Page: 64 / 136

2. Commissioning
2−30
Festo P.BE−CPX−FB32−EN en 0605NH
Pl ease n o te
If the system parameter System start" has the setting
System start with saved parametrizing and saved CPX
system equipment," modified parameter settings in the
CPX terminal will become valid immediately after Power On.
2.3.5 Parametrizing via the PLC user program (method 3)
Program−controlled access to parameters is made via the
Explicit message" programming. The addresses of the
EtherNet/IP Object Model required for this can be found in
appendix B. Information on programming this data trans
mission can be found in the manual for your controller.
In order to address the CPX terminal with FB32 you will
require the following Object descriptions:
Detailed Object descriptions can be found in appendix B.1.
Obj ect
c l asses
I nstances
(d ec .)
A tt r i b.
(d ec .)
N ame
4
d
100 ... 102 Assembly Object
102
d
1 ... 48 1, 2 Modification digital inputs, Object
103
d
1 ... 48 1 ... 6 Modification digital outputs, Object
104
d
1 ... 48 1, 2 Modification analogue inputs, Object
105
d
1 ... 48 1 ... 6 Modification analogue outputs, Object
106
d
1 ... 48 1, 2 Modification input words of technology module, Object
107
d
1 ... 48 1 ... 6 Modification output words of technology module, Object
132
d
1 1 ... 37 System Object (Global System Object)
133
d
1 1 ... 3 Status and Diagnostic Object
134
d
1 ... 40 1 ... 12 Diagnostic Trace Object
135
d
1 1 ... 13 Diagnostic Trace Status Object
Tab.2/14: Overview of Object classes for EtherNet/IP (operating mode Remote I/O)