MACHINES AND
ACCESSORIES
Page 31 of 43
8.1.1 Mounting the tool for milling
Insert the tool holder piston rod and tighten the spindle in the following way:
1. Open the spindle's protective guard (ref. III in Figure 22);
2. Remove any tools from the drill's spindle;
3. Remove the drill's spindle;
4. Remove the black cover on the head (ref. I);
5. Insert the tool holder piston rod (ref. II) in the pin, after which lock the tool holder;
6. Insert the milling cutter into the tool holder piston rod;
7. Re-close the spindle's protective guard (ref. III).
Figure
22
Tool disassembly and assembly.
During milling it is possible to keep under control the vertical feed of the tool by means of the
graduated scale located at the front of the machine (to the left of the speed table).
8.1.2 Locking the work table
Risks associated with using the machine
When milling with the longitudinal feed it is mandatory to lock the transverse feed of the table
to ensure accuracy in the work.
Conversely, for transverse milling, lock the longitudinal feed of the table.
For this purpose, the feed lock for the desired directions, is achieved by rotating the levers
located at the front part (Figure 23) and lower part (Figure 24) of the worktable.
Figure
23
Transverse limit locking.
Figure
24
Longitudinal limit locking.
I
II
III
IV
fervi.com
Summary of Contents for t047/230v
Page 36: ...MACHINES AND ACCESSORIES Page 36 of 43 12 ELECTRICAL CIRCUIT T047 230V T047 400V fervi com...
Page 37: ...MACHINES AND ACCESSORIES Page 37 of 43 12 1WIRING DIAGRAM OF THE CONTROL PANEL fervi com...
Page 38: ...MACHINES AND ACCESSORIES Page 38 of 43 13 PARTS OF THE MACHINE fervi com...
Page 48: ...MACHINES AND ACCESSORIES Page 48 of 48 fervi com...
