Fervi t047/230v, User And Maintenance Manual

Page: 29 / 52

MACHINES AND
ACCESSORIES
Page 29 of 43
7.2 Mechanical installation
1. Place the machine on a hard strong floor to prevent
vibration and/or loss of stability during processing.
2. Make 4 mounting holes on the floor, with spacings equal
to those of the mounting holes on the machine base
(Figure 21).
Figure 21 Mounting holes.
3. Secure the machine to the floor, using the 4 bolts or dowels.
4. Tighten the 4 bolts only when you have made sure that the machine is level and perfectly
horizontal. If necessary, insert rubber or sheet metal shims below the base.
5. Check the stability and safety of the Milling Drilling Machine;
Checking the fixing and stability
Always check the stability and proper mounting of the machine, before connecting the power
supply and before putting it into operation.
7.3 Electrical installation
The Milling Drilling Machine T047 comes with power cables connected to the electrical panel:
The 230V model is equipped with a heat sealed Schuko plug, whereas the 400V model does
not have a plug at the end so it is necessary for a qualified electrician to connect the plug,
which must be a three-phase 400V/50Hz.
7.4 Commissioning
Several components of the Milling Drilling Machine T047, such as the pillar, the screws for the
sliding of the work table, etc. are covered with a special protective grease and wrapped in a
plastic film. It is necessary to remove both the film and the grease, the latter with
appropriate solvents.
Danger of contact with harmful substances
The grease removal must be carried out with appropriate Personal Protective Equipment such
as: rubber gloves and mask.
Before starting the machine, check that all the movements of the spindle and the worktable,
are sliding properly. Operate the machine unloaded starting with the lowest speeds for a few
minutes. If there are no irregularities or unusual noises it is possible to proceed with the use
of the machine, otherwise contact the service centre.
fervi.com