Fayat DYNAPAC F1000T T4f, Operation & Maintenance Manual

Page: 242 / 263

F 47
Never turn the adjusting bolts more than a half turn!
If the guide rollers run excessively outwards, you should adjust the guide rollers in the opposite
direction!
- Move the machine forward and check to see if the rollers are running straight. Repeat the
adjustment if necessary.
When checking the adjustments, drive the machine until the drive wheels make two complete turns
The adjustment is correct if the teeth of the rollers run in the middle between the idlers and the front
/ rear guide rollers!
- Tighten the counter-nuts on the adjusting bolts (A) and (B) on a regular basis!
- Move the machine forward and backward to check if the rollers are running straight!
The rollers running straight is very important and directly affects their life cycle!
Guide rollers – straight running secure the
adjustment bolts (2)
The adjustment bolts are located in the front part
of the drives and at the regulator links of the guide
rollers.
If the wheels and rollers run outwards or inwards
or are not centered on the two guide rollers, side
ward tilt of the guide rollers should be adjusted.
Check whether the adjusting bolts and counter
nuts are properly tightened and retighten them if
necessary.
Guide rollers runs excessively inwards:
- Loosen the counter-nuts of both adjusting
bolts (A) and (B).
- Loosen the inner adjusting bolt (A).
- Retighten the outer adjusting bolt (B).