Fayat DYNAPAC F1000T T4f, Operation & Maintenance Manual

Page: 176 / 263

D 133
When work is finished
- Run the paver empty, then bring it to a stop.
- Turn drive lever (20) to the center position. Move the preselector (12) and selector (21) to
minimum position.
- Switch off co auger (45), vibration (27), and lights (25).
- Lift the screed by using switch (52).
- Retract the screed parts to the basic screed width with switches (50) and (51).
- Use switch (47) and (48) to lift the auger.
- Where applicable, completely extend the leveling cylinders by using switches (54) and (55).
- Insert the mechanical screed transport safeguard (74)
on both screed lifting cylinders.
- While operating the tampers at a low speed, let any
material residue drop out.
Switch the ignition (10) off
- Switch screed heater (system) off.
- Remove the leveling units and stow them away in their
boxes and close the boxes.
- Remove all parts that extend beyond the paver width.
Secure them if the paver is to be transported over public roads on a low-bed trailer.
74
Do not turn the main switch off until 100 seconds after
the ignition has been turned off!
The engine electronics require this length of time to back
up data, and such device can prevent the engine’s
electronic control module (ECM) from sustaining damage
and battery discharging.
- Read and check the operating hour meter to determine
whether maintenance work must be performed (see
chapter F).
- Cover and lock the operation panel, so as to restrain
unauthorized persons from starting and operating the
machine.
- Remove material residue from the screed and the paver and spray all parts with releas e
agent fluid.