Fayat DYNAPAC F1000T T4f, Operation & Maintenance Manual

Page: 160 / 263

D 117
1.1 Starting the paver
Before starting the paver
Before starting the diesel engine and beginning operation, the following steps must be performed.
- Daily maintenance of the paver (see chapter F)
Check the operating hours counter to determine whether or not additional
maintenance work (such as monthly or yearly maintenance) must be performed.
- Check the safety devices and protective devices.
“Normal” starting
- Set the drive lever (20) to the center position and the speed preselector (12) and the selector
(21) for traction drive / engine to minimum.
- Insert the ignition key (10) in position “0”. The lights should be switched off during starting to
reduce the current drain on the battery
Starting is not possible if the drive lever is not in the central position or if the emergency stop
button (40) is depressed
- Turn the ignition key (10) into position 3 to start the engine. Once engine has started, release
the key and it will spring-return to the “On” position. Do not let the starter run continuously
for more than 20 seconds; wait 1 minute before turning the starter again