Fayat DYNAPAC CX8, Instruction Manual, Page: 173 / 180

Maintenance - Every 2000h
4812165801.pdf 2024-04-22
Hydraulic reservoir
Fluid change
Fig. Under hydraulic reservoir (via left
side)
1. Fluid draining
2. Hydraulic reservoir
3. Valve
1
2
3
Take care when draining the hydraulic fluid. Wear
protective gloves and goggles. Take care when draining the hydraulic fluid. Wear
protective gloves and goggles.
Place a receptacle that holds at least 50 liters (13.2
gal) under the engine compartment.
Make sure that the valve (3) is closed.
Remove the fluid plug (1), and connect a drain hose
from the valve.
Open the valve (3) and allow all the oil to run out.
Reset by closing the valve and refitting the plug (1).
Deliver the drained fluid to environmentally
correct handling. Deliver the drained fluid to environmentally
correct handling.
Fill with fresh hydraulic fluid. Refer to the lubricants
specification for grade information.
Replace the hydraulic filter. See section "Maintenance
- 1000 hours".
Start the engine and operate the hydraulic functions.
Check the level in the reservoir and top off as required.
Fuel tank
- Cleaning
It is easiest to clean the tank when it is almost empty.
Fig. Fuel tank
1. Oil drain pump
1
Pump out any bottom sediment using a suitable pump,
such as an oil drain pump.
Collect the fuel and sediment in a container and
deliver to environmentally correct handling. Collect the fuel and sediment in a container and
deliver to environmentally correct handling.
Keep in mind fire risk when handling fuel. Keep in mind fire risk when handling fuel.
161