Fayat DYNAPAC CX8, Instruction Manual, Page: 101 / 180

Operation
4812165801.pdf 2024-04-22
Edge cutting/pressing (Optional)
1
2
Fig. Switch
1. Edge cutter, left/right side
2. Edge cutter/presser, Up/Down
The machine must be running to activate the edge
cutter/presser.
Selection with button (1) for use of the left or right
edge cutter/presser and the sprinkler valve for the
edge cutter/presser.
Water sprinkling of the edge cutter/presser is carried
by activating the drums’ regular sprinkler system and
then running in auto mode at the set interval.
Sprinkling of the edge cutter/presser can also be
carried out by pressing and holding the blue button on
the control lever.
When the machine is in Working mode and if the lower
left button on the lever (2) is pressed, the edge
cutter/presser is lowered to the asphalt surface by
means of a hydraulic cylinder. To return the edge
cutter/presser to its original position, press on the
upper left button on the lever to lift the edge
cutter/presser.
Note that the edge cutter/presser can also be lifted if
the machine is in Transport mode.
A bypass valve prevents the hydraulic system being
overloaded.
The standard sprinkler system should be activated first
to avoid asphalt sticking to the edge cutter/presser.
Now press and hold blue button on the front/reverse
lever in order to spray water on the edge
cutter/presser.
Fig. Replacing the tool
1. Edge presser
2. Edge cutter
3. Bolted joints
4. Holder for cutter/press wheel
4
3
3
1 2
There are two tools to choose between: a cutter wheel
for edge cutting and a conical compaction wheel for
edge pressing. In the figure the edge cutter (1) is
mounted for work. The edge cutter (2) can easily be
replaced with the edge presser by loosening the bolted
joint (3).
89