Fayat DYNAPAC CX8, Instruction Manual, Page: 105 / 180

Operation
4812165801.pdf 2024-04-22
Release the eight screws holding the outfeed drum.
Lift off the drum and bearing.
Unscrew the outfeed rubber.
Changing the brushes.
Remove the bearings and seals.
Remove the old brushes and fit the new brushes.
Refit the assembled brush drum in the spreader.
Fit the scraper iron and rubber mat.
Fit the scraper iron attachments (No.1) left and right.
Adjust the scraper iron so that it goes 1-3 mm into the
brush.
Adjust the rubber mat so that it is flush with brush,
approx. 5 mm.
Preparations before dismantling/assembly.
1
The machine should be standing on a level surface
with the engine switched off and the brakes on.
Make sure that the container is empty and does not
contain any extra material before dismantling.
Attach the lifting devices in the eyes on both sides of
the container.
1- Release the pin in the clamp and remove the clamp
from the machine.
93