Maintenance - Biweekly (Every 100 hours of operation)
2018-02-20
4812325559EN
75
Biweekly (Every 100 hours of operation)
Replace the front and rear axle oil
(ONLY ON THE FIRST 100 HOURS)
This oil replacement should be done only with
100 hours of operation. The other ones should
be done every 1,500 hours.
Never perform maintenance under the machine
when the engine is running. Always park the
machine on a leveled ground and shim the cylinders.
1.
Make sure that the machine is on a leveled ground and the
parking brake is applied.
2.
Clean the area around the drainage plug (1) and remove the
refueling plug (2).
3.
Release and remove the drainage plug and drain the oil in a
proper container.
4.
Install the drainage plug and tighten it with a 69 lb.ft (93 N.m)
torque.
5.
Refill with the recommended oil until the edge of the refueling
plug.
Replace the transmission box oil filters
(ONLY ON THE FIRST 100 HOURS)
1.
Clean the area around the base of the filters.
2.
Remove the filter elements individually with a belt wrench
and discard them.
3.
Clean inside the base of the filters and the housing of the seal
rings.
4.
Complete the new filters elements with new oil recommended
by
DYNAPAC
and lubricate the seal ring with the same oil.
Use only hydraulic oil recommended by
DYNAPAC.
5.
Install the elements individually, screwing them manually
until they reach the base of the filter, then adjust it with
another ½ turn. Don’t adjust it excessively, because the seal
ring may be damaged and it may cause leaks.
Fig.
– Differential axle
1
2
Fig.
– Transmission box oil filters
Summary of Contents for DYNAPAC CT3000
Page 2: ...2 4812325559EN 2018 02 20 ...
Page 4: ......
Page 107: ...2018 02 20 4812325559EN 103 ...
