Fayat DYNAPAC CT3000, Instruction Manual, Page: 76 / 108

Maintenance - Weekly (Every 50 hours of operation)
72 4812325559EN 2018-02-20
Lubricate the chassis joint
1. Turn the steering wheel completely to the left to have better
access to the grease fittings on the right side of the machine.
Keep personnel away from the chassis joint
while executing this operation: risk of injuries.
2. Clean all the grease fitting nozzles before performing the
lubrication.
3. Lubricate each grease fitting with approximately 5 manual
cycles of the grease recommended by DYNAPAC.
Certify that the grease has penetrated the bearings and that
a small excess came out of them and from the grease fittings.
Use only grease recommended by DYNAPAC.
4.
If the grease hasn’t penetrated, it will be necessary to relief
the bearing with a hydraulic jack, and to repeat the steps
above.
Lubricate the steering system joints
1. Clean all the grease fitting nozzles before performing the
lubrication.
2. Lubricate each grease fitting (front and rear, on each side)
with approximately 2 manual cycles of the grease
recommended by
DYNAPAC. Use only a hand grease fitting.
Use only grease recommended by DYNAPAC.
3. Certify that the grease has penetrated the bearings and that
a small excess came out of them and from the grease fittings.
It is recommended to keep a little bit of grease in the grease
fitting, because it helps preventing the deposit of dirt on it.
Fig.
– Chassis joint
Fig.
– Steering joints