27
Revision date: 02.16.23
111628E
ASSEMBLE THE DRAIN MANIFOLD — continued
3
Assembly Instructions
11. Place the 12' channels on the frame if needed and adjust the
entire drain manifold (up or down) to allow the channel drain
elbows to be placed inside the horizontal tubes. Tighten the
hanger bolts.
NOTE:
Do not set the manifold too high. Verify that the end
of each fodder channel remains on the horizontal tubes of
the metal fodder frame.
No weight from the fodder channels
should rest on the drain manifold horizontal tubes.
12. If this has not been done yet, assemble and install the
remaining 111906 Sammy, 111907 hanger, 3/8" threaded rod,
and 3/8" hardware to secure the lower tube to the main frame.
13. Install the upper tube and cap and the lower tube, drain
end elbow and extension to complete the drain manifold.
Add primer and cement and secure tubes to cross
fittings.
FOLLOW ASSEMBLY INSTRUCTIONS ON PVC
CONTAINERS!
NOTE:
Angle and use of the lower 90° elbow depends on
application. Extension tube is constructed using leftover PVC
tube. Additional tubing can be purchased locally, or call your
sales representative for additional information. Install this last
and after the supply manifold is assembled and attached to
the frame.
14. Continue with the assembly and installation of the supply
manifold.
Lower Tube with 90° Elbow
— Length of
vertical tube depends on application and
height of drain manifold on the frame. Use of
extension tube depends on location of drain
and design of the drain system.
Step 12:
Install final
assembled hanger.
Upper Tube with Cap
—
Do not cement cap to
tube
. Apply primer and
cement to secure tube to
cross fitting.
