10
10
111628E
Revision date: 02.16.23
1
ASSEMBLE MAIN FRAME: Attach Support Arms (End Frames)
Gather the parts and complete the steps that follow to attach the
support arms to the assembled end support frames only.
Do not
attach the support arms to the middle support frame at this time.
These are installed later.
Assembly Instructions
Required parts:
• (2) Assembled end support frames (from previous page).
These include
the longer 111763A base rail. Do not use the assembly with the
111763B (shorter) base rail.
• (28) S15P036 Square Tube (plain) for support arms
• FA4482B Tek Screws and Magnetic Nut Setter (3/8" x 2-9/16")
ATTENTION:
Install Tek screws as shown for best results and a uniform
appearance.
Review all diagrams for clarification.
Complete these steps:
1. Position one end support frame on a flat surface.
2. Slide one S15P036 square tube into the lower 4-way connector and
secure it in place using an FA4482B Tek screw.
3. Repeat this process to attach all remaining support arms to complete the
first end support frame. See completed end support frame to the right.
4. With assistance, carefully move the frame to the location where the
fodder system will be assembled.
5. Repeat the above steps to assemble the remaining end support frame.
6. Continue with the assembly of the two (2) long base rails as shown on
the next page.
S15P036
S15P036
S15P036
S15P036
111763A Base Rail
FA4482B
Tek Screws
FA4482B
Tek Screws
ASSEMBLE END SUPPORT FRAME
